Stans Notubes Sealing Yellow Tape - 9 m

Notubes Yellow Tape create an airtight seal on Notubes ZTR rims and others wheelsets. You have the choice between various width depending on the internal width of your rim. 10 yard for up to 4 wheels of 29". Sold without valves. Yellow Rim Tape by itself is not a tubeless conversion kit, it requires a black rubber NoTubes Rim Strip to achieve a secure tubeless setup

Features

• Yellow Tape to seal the spoke holes
• 10 yard for up to 4 wheels of 29"
• Various width available depending on the internal width of your rim
  - 25 mm for rims with internal width of 21 to 25 mm
  - 27 mm for rims with internal width of 25 to 27 mm
  - 30 mm for rims with internal width of 28 to 30 mm
  - 33 mm for rims with internal width of 31 to 33 mm
  - 36 mm for rims with internal width of 34 to 36 mm
• Tubeless valve not included
• Installation : Clean the rim thoroughly with degreaser and start applying the tape opposite the valve. Begin by pressing down a short section (about 50-70mm) so it's stuck firmly across the rim. Then hold the wheel between your feet and apply about 25cm of tape at a time. Pull the tape as tightly as you can while pressing it down onto the rim. The tape should go on in a smooth manner, with no bubbles or wrinkles. You might need to use a side-to-side waggling motion to get the tape to form to the rim properly. Always maintain very high tension on the tape - literally as hard as you can pull. Overlap the ends of the tape about 70-100mm and cut with scissors. Cut a small hole in the tape for the valve and make it exactly the size of the rim, either by trimming with a very sharp scalpel or using light downward strokes of a small round file. Press down the tape to make sure it's well stuck down all the way round, including around the sidewall area.
• Yellow Rim Tape by itself is not a tubeless conversion kit, it requires a black rubber NoTubes Rim Strip to achieve a secure tubeless setup

Weight : only 5 gr per wheel