A real beauty product for your bike, Slicy Frame Protector kit will ensure your bike’s longevity and brightness. Slicy universal frame protection is easy to install and provides durable protection against scratches, chips, shuttle rub, and whatever else is thrown it’s way. The roll of 95 mm is available in 5m or 10 m and in Matt or Gloss finish to fit all kind of bikes and sizes . Slicy high-end bike protection film has a perfect clarity and finish, optimized thickness to enhances impact and abrasion resistance. The top coat has a self-healing and superhydrophobic properties.
Features :
High quality polyurethane film
Width : 95 mm
Length : 5 m or 10 m
Thickness: 160 microns
Anti-uv treatment
Non-yellowing
Self-healing properties
Anti-adherent (mud sticks less easily)
Available in Matte or Gloss
Included in the kit :
squeegee
cleaning wipe
installation shampoo
The installation of a Sublimistick Integral protection requires calm and thoroughness. If you are not sure of your skills, we invite you to contact your nearest Slicy dealer for a perfect set-up.
Preparation :
Make sure you are in a clean and warm, indoor space (17°C to 27°C).
Clean and degrease your bike paying close attention to every little detail.
Remove inconvenient components or old decals to facilitate the installation.
Ensure the bike has been allowed to dry for some hours.
Fill the spray bottle with our install shampoo. Add 0.5ml for 0.5L of warm water.
Thoroughly wash your hands.
Installation :
Spray water to your fingers.
Peel the section of Sublimistick off and spray water immediately on the sticky side.
Spray water on the frame’s location.
Apply the wet Sublimistick section to the frame. Center and line up the piece according to the diagram.
Repositionining is possible if the Sublimistick section is still wet.
To move, peel back, add further water to the frame and Sublimistick section then re-apply in correct location.
Use the Slicy squeegee to remove water and air. Start at the centre of the Sublimistick section and pull the water and air to the outside.
Use the microfiber to collect any excess water.
Wait few minutes and use your fingers to check if all edges are firmly pressed down.
For a perfect finish, use the hair dryer to dry the Sublimistick sections. Do not overheat.
Repeat these steps for each section to be protected
A 3mm gap between Sublimistick sections is recommanded
Let your bike dry in a warm workspace for 24h.
Do not ride or wash your bike for 24h.
Removal :
Use a hair dryer to heat the adhesive.
Peel back a corner and remove remove the section very slowly.
Aucun avis pour le moment