RRP Proguard front mudguard 2023

The ProGuard is RRP's amazing new range of FRONT and REAR mudguards for disc brake mountain bikes offering unmatched protection from mud and spray, it’s perfect for Trail, Enduro or Downhill racers and essential for the weekend warrior looking for the very best protection. RRP design intent was to increase the tyre clearance, improve fit, and reduce the mud clogging issues seen with this type of mudguard. The MINI offers a very compact design for all year round protection, The STANDARD offers superb protection in a shorter more compact design, whereas the longer MAX PROTECTION version (21mm longer at front than the STANDARD and 68mm longer at the rear) offers incredible unmatched levels of protection.

Features

• INDENT FOR FORK BRACE GIVING EXTRA 4MM OF TYRE CLEARANCE
• 24 CROWN HOLES THAT OFFER A MASSIVE AMOUNT OF FIT OPTIONS
• SNAP-OFF HOLE COVERS REDUCE SPRAY FROM TRAVELLING THROUGH UNUSED HOLES
• LONG FRONT TO COPE WITH HIGH SPEED SPRAY
• SMALLER TURN DOWN AT FRONT FOR BETTER TYRE CLEARANCE AND TO REDUCE BLOCKAGES
• REAR FLICK OFFERS EVEN MORE PROTECTION WHEN THE WHEEL IS TURNED
• STICKER RECESS OFFERS GREATER PROTECTION FOR STICKER ADHESIVE
• SEAL PROTECTION INCREASED WITH OUR ACLAIMED SEAL SHIELD DESIGN
• MINI : 386 MM LONG
• STANDARD : 494 MM LONG
• MAX : 582 MM LONG

Included

• One Proguard mudguard
• 6 zip ties

Fitting

1. Slide the guard into position with the wheel in
2. Hold the guard in position making sure it tracks the tyres equally both ends
3. You can now see which holes you need for the most secure fit to your fork brace
4. Remove guard and push out / snap-off these holes
5. NOTE: Add clear tape to areas the guard contacts the fork to reduce scratches
6. Tighten zip ties lightly, stand back and check alignment
7. You can still grab the arms around the fork legs and twist them to raise/lower the back or front of the guard for final adjustment if needed
8. Once happy you must tighten the zip ties with fat pliers as tight as possible (remember zip ties don’t’ scratch forks….loose zip ties do!)
9. Cut off excess zip ties
10. Before use, ensure the guard doesn't hit the frame when bottoming the fork

Important

• Remove mudguard every few rides to clean the brace / threads and fork legs
• DO NOT USE IN STICKY / CLAGGY MUD AS IT MAY BLOCK AND CAUSE INJURY OR DAMAGE
• MIN CLEARANCES - 15mm from the tyre when fitted and 10mm from the frame (on bottoming)
• INSPECT BEFORE YOU RIDE: DO NOT USE IF DAMAGED IN ANY WAY AS CONTINUED USE MAY LEAD TO FAILURE OR INJURY

Weight : Standard 119 gr, Max 133 gr, Mini 85 gr