Slicy Universal Crank Protection

Slicy new Universal crank armo protectionis a real beauty treatment for your crank. It provide longevity and brightness to your crank and it's compatible with most brands and models

Completely universal and flexible, Slicy Bike Crank Protection fits most brand and models

Compatible with the following brands and models :

• Shimano (XT/XTR)
• Praxis
• E-thirteen
• Sram
• Quarq
• Race Face
• FSA sans capteur de puissance
• Rotor (Inspider Vegast / Kapic)
• Truvativ

Some brands or models are not compatible :

• Rotor
• Hope
• Shimano Deore
• Race Face Altas
• E-thirteen LG 1

Crank arm length : 165mm to 175mm.

Features :

• High quality polyurethane film
• Thickness: 160 microns
• Anti-uv treatment
• Non-yellowing
• Self-healing properties
• Anti-adherent (mud sticks less easily)
• Available in Matte or Gloss

Included in the kit :

• squeegee
• cleaning wipe
• installation shampoo

The installation of a Sublimistick protection kit requires calm and thoroughness. If you are not sure of your skills, we invite you to contact your nearest Slicy dealer for a perfect set-up.

Preparation :

• Make sure you are in a clean and warm, indoor space (17°C to 27°C).
• Clean and degrease your crank paying close attention to every little detail.
• Remove inconvenient components or old decals to facilitate the installation.
• Ensure the crank is copmpletely dry from some hours.
• Fill the spray bottle with our install shampoo. Add 0.5ml for 0.5L of warm water.
• Thoroughly wash your hands.

Installation :

• Identify Sublimistick sections using the diagram.
• Spray water to your fingers.
• Peel the section of Sublimistick off and spray water immediately on the sticky side.
• Spray water on the crank's location.
• Apply the wet Sublimistick section to the crank. Center and line up the piece according to the diagram.
• Repositionining is possible if the Sublimistick section is still wet.
• To move, peel back, add further water to the Crank and Sublimistick section then re-apply in correct location.
• Use the Slicy squeegee to remove water and air. Start at the centre of the Sublimistick section and pull the water and air to the outside.
• Use the microfiber to collect any excess water.
• Wait few minutes and use your fingers to check if all edges are firmly pressed down.
• For a perfect finish, use the hair dryer to dry the Sublimistick sections. Do not overheat.
• Repeat these steps for each section of Sublimistick.
• Kits are designed with a 3mm gap between Sublimistick sections.
• Let your bike dry in a warm workspace for 24h.
• Do not ride or wash your bike for 24h.

Removal :

• Use a hair dryer to heat the adhesive.
• Peel back a corner and remove remove the section very slowly.