RRP Proguard mudguard provide high level of protection and great coverage. It's available at PureBike in 3 sizes and comes with 6 installation zip ties.
The ProGuard is RRP's amazing new range of FRONT and REAR mudguards for disc brake mountain bikes offering unmatched protection from mud and spray, it’s perfect for Trail, Enduro or Downhill racers and essential for the weekend warrior looking for the very best protection. RRP design intent was to increase the tyre clearance, improve fit, and reduce the mud clogging issues seen with this type of mudguard. The MINI offers a very compact design for all year round protection, The STANDARD offers superb protection in a shorter more compact design, whereas the longer MAX PROTECTION version (21mm longer at front than the STANDARD and 68mm longer at the rear) offers incredible unmatched levels of protection.
Features
INDENT FOR FORK BRACE GIVING EXTRA 4MM OF TYRE CLEARANCE
24 CROWN HOLES THAT OFFER A MASSIVE AMOUNT OF FIT OPTIONS
SNAP-OFF HOLE COVERS REDUCE SPRAY FROM TRAVELLING THROUGH UNUSED HOLES
LONG FRONT TO COPE WITH HIGH SPEED SPRAY
SMALLER TURN DOWN AT FRONT FOR BETTER TYRE CLEARANCE AND TO REDUCE BLOCKAGES
REAR FLICK OFFERS EVEN MORE PROTECTION WHEN THE WHEEL IS TURNED
STICKER RECESS OFFERS GREATER PROTECTION FOR STICKER ADHESIVE
SEAL PROTECTION INCREASED WITH OUR ACLAIMED SEAL SHIELD DESIGN
MINI : 386 MM LONG
STANDARD : 494 MM LONG
MAX : 582 MM LONG
Included
One Proguard mudguard
6 zip ties
Fitting
Slide the guard into position with the wheel in
Hold the guard in position making sure it tracks the tyres equally both ends
You can now see which holes you need for the most secure fit to your fork brace
Remove guard and push out / snap-off these holes
NOTE: Add clear tape to areas the guard contacts the fork to reduce scratches
Tighten zip ties lightly, stand back and check alignment
You can still grab the arms around the fork legs and twist them to raise/lower the back or front of the guard for final adjustment if needed
Once happy you must tighten the zip ties with fat pliers as tight as possible (remember zip ties don’t’ scratch forks….loose zip ties do!)
Cut off excess zip ties
Before use, ensure the guard doesn't hit the frame when bottoming the fork
Important
Remove mudguard every few rides to clean the brace / threads and fork legs
DO NOT USE IN STICKY / CLAGGY MUD AS IT MAY BLOCK AND CAUSE INJURY OR DAMAGE
MIN CLEARANCES - 15mm from the tyre when fitted and 10mm from the frame (on bottoming)
INSPECT BEFORE YOU RIDE: DO NOT USE IF DAMAGED IN ANY WAY AS CONTINUED USE MAY LEAD TO FAILURE OR INJURY
